Expert introduces the operation and maintenance of water dispensers

Please check before use

1. Whether the filter housing of the water purification device is damaged or scratched.

2. After connection, please carefully check that all joints of the entire machine are leak free. If a leak is found, tighten it.

Installation and use

Firstly, unscrew the filter housing of the water purification equipment, place the filter element into the filter housing, and tighten it with a special wrench.

2. Close the user's inlet valve, remove the identified water pipe connection components, connect the water purifier in series with the pipe fittings, and then fix the water purifier to the wall with self tapping screws.

3. Open the inlet valve and clean water outlet valve, rinse the filter element of the water purification device for 5 to 1 minute, and use it after rinsing with clean water.

maintain

Regularly replace or clean the filter element to maintain pure water quality. In order to ensure that the filter elements fully utilize their respective performance and ensure clean water quality and normal water flux, water purification depends on the quality of the water source and the amount of impurities contained. Depending on the user experience:

When users feel a significant decrease in water output or a deterioration in taste, please consider replacing or cleaning the filter element;

The replacement time of the filter element completely depends on the user's water quality and the amount of purified water used. However, if a safe replacement frequency is used, the quality of the purified water produced by the normal operation of the water purifier can be guaranteed.

Therefore, the recommended replacement intervals for various filter cartridges are for reference only.

Filter cleaning

Unscrew the filter housing, remove the filter element, remove dirt from the surface of the filter element, rinse with clean water, reinstall it into the filter element housing, and restore it to its original state after installation

Water production rate: 120l/hour

The filter configuration can be installed according to the local water machine of the customer!

Maintenance precautions

1. It is recommended to open the inlet ball valve during drainage and close it when not draining;

When not in use for a long time, the inlet ball valve should be closed to cut off the water source;

3. When used again after long-term use, it should be considered as the first use;

After replacing the filter element, clean the "0" type sealing ring, then screw the filter housing into the end cover again and tighten the filter housing until there is no water leakage.

5. Disinfection should be carried out when necessary